Allow 20-30 minutes for dry to touch and 24 hours for full cure.If you have missed a spot or have an imperfection to correct, allow 24 hours to cure before scuffing that area and re-applying. Once product has been applied do not wipe over the same area again. Apply thinly and quickly to one panel at a time. Always apply to a small inconspicuous area to test results before going over entire vehicle. For small hard to get to areas, wet one of our Recycled Knit Rags and wipe on. After surface is completely dry, with our Wipe-On Clear Coat wet a provided A pplicator Pad in a paint tray for large areas.*(If you are wanting to achieve a Satin Finish, mix Matte and Gloss Wipe-On Clear Coat 50/50 then mix 8 parts clear coat to 1 part catalyst.)*īlow off provided Applicator Pad before use to get rid of loose fibers. ![]() Mixed product will have a two hour pot life at 77 degrees. Mix our required Clear Catalyst at a mixing ratio of 8:1 to achieve chemical resistance. ![]() Then with our Wax & Grease Remover wet one rag, then wipe on while drying with another clean dry rag before applying the clear coat.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |